Fairly priced Residential & Commercial HVAC Repair, Maintenance, & Install Services in Alderman, FL.

Confirm the thermostat is set to Cool, the setpoint is below room temperature, and replace the batteries if needed. Check the circuit breaker and outdoor disconnect, and ensure any float/safety switch in the drain pan hasn’t tripped. Inspect or replace a clogged air filter and make sure the air handler/furnace door is fully closed to engage the safety switch. If it still won’t start, turn the system off and contact Comfort Control Specialists for fast diagnostics and same-day repair.

Verify the thermostat mode is Cool and the outdoor unit is running, then reset any tripped breaker. Replace a dirty filter and clear debris around the condenser to restore airflow. If the indoor coil is iced, set the fan to On and AC to Off for 30–60 minutes to thaw, then try cooling again. If warm air persists, you may have a refrigerant or compressor issue—Comfort Control Specialists can locate leaks, test pressures, and perform EPA-compliant repairs.

Turn the system off to prevent damage and replace a dirty air filter. Clear a clogged condensate drain by vacuuming the outside drain line and flushing it with distilled vinegar. Check that the float switch isn’t tripped and that the drain pan isn’t cracked. If leaking continues or the coil refreezes, Comfort Control Specialists can clear and treat the drain, repair pan or switch issues, and address root causes like airflow or refrigerant problems.

Shut the system off if you hear grinding, screeching, banging, or repeated clicking to avoid motor or compressor damage. Remove obvious debris from the outdoor fan and tighten loose service-panel screws. Do not keep running the unit if the noise persists or there’s a burning smell. Comfort Control Specialists can quickly diagnose and replace failing capacitors, motors, bearings, or fan blades to restore safe operation.